If you have ever had to change a tire on your Chevy Silverado, you know that getting the jack out is only half the battle. Putting it back in can be just as challenging, especially if you are not sure what you are doing. In this article, we will provide a step-by-step guide on how to put the jack back in Silverado, so you can do it with confidence and ease.
Step 1: Clean the Jack
Before putting the jack back in your Silverado, make sure it is clean and free of debris. Use a clean cloth or paper towel to wipe away any dirt or grime that may have accumulated on it during use.
Step 2: Position the Jack
Once the jack is clean, position it in the storage compartment located behind the rear seat of your Silverado. You should see a designated spot for the jack that will hold it securely in place.
Step 3: Secure the Jack
After you have positioned the jack in the storage compartment, make sure it is secured in place. Check to see if there are any straps or clips that can be used to hold the jack down. If there are no straps or clips, try placing the jack in a way that it will not move around while you are driving.
Step 4: Reassemble the Compartment
The jack storage compartment in your Silverado is likely to have other items stored in it, such as the lug wrench and tire iron. Before closing the compartment, make sure to reassemble it properly and ensure that everything is in its proper place. This will help prevent any rattling or shifting of items during driving.
Step 5: Test the Jack
Once you have reassembled the jack storage compartment, test it by giving it a gentle shake to make sure the jack is secure. If the jack moves around, you may need to reposition it or find additional ways to secure it.
How do you use the jack on a 2017 Silverado?
To use the jack on a 2017 Silverado, locate the designated jack points under the vehicle and place the jack there. Turn the jack handle or use a wrench to raise the vehicle until the tire is off the ground. Then, remove the lug nuts and change the tire as needed. Remember to always follow the manufacturer’s instructions and take necessary safety precautions when using the jack.
Where does Jack’s stand to go on Silverado?
The jack stands on a Silverado go under the vehicle’s recommended jacking points to support it after it has been lifted with a jack. The exact location will vary depending on the model and year of the Silverado, but the recommended jacking points can typically be found in the owner’s manual or on a sticker under the vehicle. It is important to use jack stands to prevent the vehicle from falling and causing injury or damage.
How to remove the jack from the 2010 Silverado?
To remove the jack from a 2010 Silverado, first, ensure that the vehicle is safely lowered and the weight is off the jack. Then, loosen and remove any straps or clips securing the jack in place in the storage compartment. Lift the jack out of the storage compartment and inspect it for any signs of damage or wear. Clean the jack if necessary before storing it away in a safe and secure location. Remember to always handle the jack with care to avoid injury or damage to the vehicle.
Conclusion
Putting the jack back in your Silverado may seem like a small task, but it is an important one that should not be overlooked. By following these simple steps, you can ensure that your jack is stored safely and securely, ready for the next time you need to change a tire. Remember, safety should always be a top priority when working with your vehicle, so take your time and be careful when handling the jack.
